![]() ![]() ![]() At this point the 2 holes will overlap almost completely. Repeat this process until you've increased each hole size to 3/16" drill bit. After going all the way through the board, increase the size of the drill bit to the next size up and drill directly in the same 2 holes making them slightly bigger. Next, start with a small drill bit (3/32" or 7/64") and drill a hole at the angle on the center of each dot you marked. On the side of your board, mark a 12 degree angle in line with the dots for reference. Using the end of your lightning cable for reference, mark 2 dots in the middle of the wood right on the edges of the metal end of the cable. Using multiple sized drill bits and increasing in size gradually we create this exact hole we need.įirst, take a piece of scrap wood that is 1" or so tall. The goal here is to create a hole just wide enough for the lightning cable end to slip into snug. That will, of course, work for wired charging, too - which will always be faster than MagSafe or other wireless charging options.This step is important! If you don't practice on a piece of scrap wood creating the hole, you most likely will end up with too big of a hole that won't work very well for securing the cable.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |